Soft-start functionality in LED driver soothes eyes

One of the less obvious differences between incandescent light bulbs and LED-based lights is the speed at which they start up. An incandescent bulb requires some time to reach full brightness after you switch it on, and that delay gives the eye a comfortable interval for adjusting to the bright light. LED-based lights lack this property. Instead, their brightness goes from zero to 100% almost instantly. That property is welcome in a camera flash, but rather annoying for general lighting.

Fortunately, you can use the thermal-foldback protection built into an LED-driver IC (MAX16832) to emulate the natural soft start of an incandescent bulb. Figure 1 shows the typical application circuit for this IC.

Figure 1: A typical application circuit for the MAX16832.
(Click this image to view a larger, more detailed version)

A negative-temperature-coefficient resistor (NTC) connected to pin 8 implements the thermal-foldback protection, by reducing output current when the temperature of the LED string exceeds a specified temperature. A constant-current source drives 25μA through this resistor, which is thermally attached to the LEDs. When the resulting NTC voltage drops below 2V (for which R_NTC < 80kΩ), an internal comparator alters (lowers) the bandgap reference voltage used by the driver for regulating the LED current. See the LED driver block diagram (Figure 2). The graph on the right in Figure 3 shows this action for a programmed LED current of 666mA. (The R_SENSE value is 300mΩ).

Figure 2: The simplified diagram demonstrates the internal operation of the IC in Figure 1.
(Click this image to view a larger, more detailed version)

Figure 3: This graph of LED current vs V_{TEMP_I} assumes R_SENSE = 300mΩ.
(Click this image to view a larger, more detailed version)

Page 2: LED current ramp
Page 1 | 2

TECH PAPER
1. Supporting Digital Television Trends with Next-Generation FPGAs

TECH PAPER
2. Using 10 and 15 MBd Optocouplers and Optically-isolated Gate Drivers AC Plasma Display Panels

TECH PAPER
3. Designing Low Power, Multi-Primary Technology for Mobile Phone Displays

TECH PAPER
4. ChromotionHD 2.0 for Chrome 5000E Series GPUs